UBL ©About StorefrontMy AccountMy Shopping Cart ContactSupport

Green ChemistryLubricant SolutionsProduct ShowcaseGreen Retailers
R&D HistoryEndorsementsRenewable Lubricants ManualCase StudiesReferences
 UBL Home > Product Catalog: Bio Degreasers - Cleaners > Bio Parts Degreaser + Bio Corrosion Inhibitors - BCI™
 A Green Chemistry Company Enabling U.S. Oil Independence 

Biobased Products 
Overview 
Bio General Purpose Degreaser-Cleaner 
Bio Parts Degreaser 
Bio Parts Degreaser + Bio Corrosion Inhibitors 

 

Recommend     Print  


Product Info Specifications MSDS Compare Testimonials


 

 

Bio Parts Degreaser + Bio Corrosion Inhibitors

Material Safety Data Sheet (MSDS)

NFPA CODE:   HEALTH: 1  FIRE: 1  REACTIVITY: 0

HMIS CODE:   HEALTH: 1  FIRE: 1  REACTIVITY: 0

 SECTION 1 - HAZARDOUS INGREDIENTS

       
    • This material does not contain any chemical listed as a carcinogen or potential carcinogen by OSHA, IARC Monographs or National Toxicology Program.
       
    • This material has no known hazards.

 SECTION 2 - PHYSICAL DATA


 

EVAPORATION RATE
(n-Butyl Acetate=1)

Approx. 0

PERCENT VOLATILE:

0 %

BOILING POINT:

< 300 oC (572 oF)

VAPOR DENSITY (Air = 1):

< 1

SPECIFIC GRAVITY (H2O = 1):

0.88 @ 15.6 oC

SOLUBILITY IN WATER:

Insoluble

APPEARANCE AND ODOR:

Light Golden liquid.  Mild odor.


 SECTION 3 - FIRE FIGHTING MEASURES


 

FLASH POINT (PMMC):

300.2 oF, 149 oC (PMCC)

UPPER FLAMMABLE LIMIT:

Not Determined

LOWER FLAMMABLE LIMIT:

Not Determined

EXTINGUISHING MEDIA: (Air = 1):

CO2, dry chemical, alcohol foam.  Water can be used to cool and protect exposed material.

SPECIAL FIRE-FIGHTING PROCEDURES:

Recommend wearing self-contained breathing apparatus.  Water may cause splattering.  Material will float on water


 SECTION 4 - HEALTH HAZARD DATA


THRESHOLD LIMIT VALUE:

Contains vegetable oil. OSHA PEL of 5 mg per cubic meter. ACGIH STEL of 10 mg per cubic meter for mineral oil mists.

EFFECTS OF OVEREXPOSURE:

May cause eye and skin irritation.  Low order of toxicity.


 SECTION 5 - EMERGENCY AND FIRST AID PROCEDURES:


 

ORAL:

DO NOT INDUCE VOMITING. If conscious, give 2 glasses of water. Get immediate medical attention

EYE:

Flush with water at least 15 minutes. Get medical attention if eye irritation develops or persists.

SKIN:

Wash with soap and water. Remove contaminated clothing. Get medical attention if irritation develops. Launder contaminated clothing before reuse.

INHALATION:

Remove exposed person to fresh air if adverse effects are observed.  If breathing is labored, administer oxygen.  If breathing has stopped, apply artificial respiration.  If irritation persists, get medical attention.

ADDITIONAL:

Note to physician: Treat symptomatically.


 SECTION 6 - STABILITY AND REACTIVITY


 

STABILITY:

Material is normally stable at moderately elevated temperatures and pressures.

INCOMPATIBILITY:

Strong oxidizing agents.

POLYMERIZATION:

Will not occur.

THERMAL DECOMPOSITION:

Smoke, carbon monoxide, aldehydes and other products of incomplete combustion.


 SECTION 7 - SPILLS OR LEAK PROCEDURES


 

STEPS TO BE TAKEN IN CASE MATERIAL IS SPILLED OR RELEASED:

Prevent entry into sewers and waterways. Pick up free liquid for recycle/disposal. Absorb small amounts on inert material for disposal.

WASTE DISPOSAL METHOD:

This material is non-hazardous for disposal under RCRA. Disposal should be in compliance with federal, state and local laws.


 SECTION 8 - HANDLING AND STORAGE


 

HANDLING PROCEDURES:

Keep containers closed when not in use. Wash thoroughly after handling. Launder contaminated clothing before reuse.

STORAGE PROCEDURES:

No special storage precautions required.

OTHER PRECAUTIONS:

Do not pressurize, cut, weld, braze, drill, grind, or heat empty containers, as some flammable, hazardous, or combustible residue may be present. Avoid breathing enclosed oil vapors. Keep container tightly closed.


 SECTION 9 - EXPOSURE CONTROL - PERSONAL PROTECTION


 

VENTILATION PROCEDURES:

Use local exhaust ventilation to control mists or vapors. Additional ventilation or exhaust may be required to maintain air concentrations below recommended exposure limits.

GLOVES PROTECTION

Use nitrile or neoprene gloves.

EYE PROTECTION:

Safety glasses, chemical goggles or face-shield.

RESPIRATORY PROTECTION

Under normal use conditions, respirator is not usually required.  Use NIOSH/MSHA approved disposable dust/mist mask if the recommended exposure limit is exceeded.

Use self-contained breathing apparatus for entry into confined space, for other poorly ventilated areas and for large spill clean-up sites.

OTHER PROTECTIVE EQUIPMENT

Long sleeve shirt is recommended. Wear a chemically protective apron when contact with material may occur. Launder contaminated clothing before reuse.


The information presented herein has been compiled from sources considered to be dependable and is accurate to the best of United Bio Lube's knowledge; however, United Bio Lube makes no warranty whatsoever, expressed or implied, of MERCHANTABILITY OF FITNESS FOR THE PARTICULAR PURPOSE, regarding the accuracy of such data or the results to be obtained from the use thereof.  United Bio Lube assumes no responsibility for injury to recipient or to third persons or for any damage to any property and recipient assumes all such risks.


 

For assistance, please call (650) 213 - 9979


 
Home |  About |  My Account |  My Shopping Cart |  Contact
Copyright © 2007 United Bio Lube  All rights reserved.
BlogsJobsNews
 Bio 2-Cycle Engine Oils 
 Bio Air Tool Oils 
 Bio Assembly Oils 
 Bio Bar & Chain Oils 
 Bio Chain & Cable Oils 
 Bio Corrosion Inhibitors 
 Bio Degreasers - Cleaners 
 Bio EP Greases 
 Bio Firearm Lubricants 
 Bio Food Grade Gear Oils 
 Bio Food Grade Greases 
 Bio Food Grade Hydraulic Fluids 
 Bio Food Grade Lubricants 
 Bio Gear Oils 
 Bio Hydraulic Fluids 
 Bio Metalworking Fluids 
 Bio Mold Release Fluids 
 Bio Motor Oils 
 Bio Oven Lubricants 
 Bio Penetrating Lubricants 
 Bio Rock Drill Oils 
 Bio Saw Guide Oils 
 Bio Slideway Oils 
 Bio Spindle Oils 
 Bio Tractor Fluids 
 Bio Transmission Fluids 
 Bio Turbine R&O Fluids 
 Bio Vacuum Pump Oils